Sunday, November 29, 2009

Wing Ribs, Rear Spar

Long time without posts:(
I have been very busy with work lately and just haven't had much time. This past week i managed to get a few hours in and concentrated on cleaning up the ribs as this is very time consuming and work that i can do on my own.
i have worked on the rear spar and doublers for both wings, as well as the tie-down 933 for the left.

From Pete and Tad's RV-9a Build

From Pete and Tad's RV-9a Build

From Pete and Tad's RV-9a Build

From Pete and Tad's RV-9a Build

From Pete and Tad's RV-9a Build

From Pete and Tad's RV-9a Build

From Pete and Tad's RV-9a Build

From Pete and Tad's RV-9a Build

From Pete and Tad's RV-9a Build


i did some organizing of the parts and hardware too. trying to get them all out of the brown little bags and labeled into a container where i can see them. half way through them now.

i think tad and i need to make some decisions about the pitot as well. we will install the wing conduit as per the van's guidelines but if we go with another type of instrument in the panel we may need to get something different for the pitot. just not sure yet.

No comments: